CORRECT CRAFT G21 Manuel de l'opérateur télécharger pdf (Page 3)

• Even though the system is only 12 or 24 volts, both the PV

array and battery can contain lethal amounts of electrical

power.

• Do not splash water on the controller, do not allow water to

enter the ventilation slots.

• Do not touch the heatsink. Under certain operating condi-

tions, the heatsink can become hot.

• Always install the controller in a vertical position. Ensure

adequate space for ventilation, and never block the ventila-

tion slots.

• Do not short-circuit the PV array while connected to the

controller. This will damage the controller.

• Do not exceed the current ratings of the controller.

2.0 QUICK START INSTRUCTIONS

This section provides a brief overview of how to get started

using the ProStar controller. However, please review the

entire manual to ensure best performance and years of

trouble-free service.

1. Mount the ProStar to a vertical surface. Allow space above

and below the controller for air flow. The heatsink MUST be

in a vertical (up & down) position.

2. Make sure the PV and load currents will not exceed the

ratings of the ProStar model being installed.

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

CORRECT CRAFT G21 Manuel de l'opérateur Page 3